Microsonic LCA-2 Manuel d'utilisateur télécharger pdf (Page 45)

Visualisation of measurements Page 45 of 51

GRAPHIC PRESENTATION

The displayed output characteristics correspond to the settings in the input mask.

The position of the vertical line below the target (red wall) changes proportional to the measured distance.

The expected output voltage and the expected output current is calculated on the values as given in the

input mask and showed in the lower part of the window; thus they should match with the actual analogue

signal on the sensor output (within the specified accuracy). To have correct results the values in the input

masks have to be identical to the values stored in the sensor!

The LED's D1 and D2 are showing the required state of the switching output S1 and S2, respectively the

analogue output. To have correct results the values in the input masks have to be identical to the values

stored in the sensor.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51

Pas de commentaire

Microsonic LCA-2 Manuel d'utilisateur Page 45